Actually Derrick I have NEVER screwed up a gun with a Dremmel.

There was an Orbit Valve that I messed up a bit when doing some deburring while working for them. A carbide burr at 30K is MUCH less forgiving than polishing points. Hmm Figure about 20 - 30 full custom 1911s and the cost would be about the same I bet or maybe a bit low :D Of course they welded it and recut it and it was good as new. Then there was the set of Big Valve Big Block Chevy heads that I screwed up the valveseat on. :eek but no guns.

The one gun that I FUBARED so far wasnt with a Dremel and thats ALL I am saying.

Larry P